Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Device sends %CO2% instead of the actual value
After playing around with the CM1102 and CDM7160 sensors i found out that apparently such fluctations are normal, but the CM1102 solves this by having a large averaging buffer built in, while for the CDM7160 it has to be in the software. Up to now i was averaging the last 2 values, now i switched to 6 which made it quite stable
The sensor is read each 20 seconds, so this means that within 2 minutes any change would be reflected
You can try it out by updating to the latest firmware with "otah"

Messages In This Thread
RE: Device sends %CO2% instead of the actual value - by admin - 10-06-2016, 04:03 AM

Forum Jump:

Users browsing this thread: 1 Guest(s)