11-12-2016, 05:08 AM
aahh i missed the "not". Well - according to the manufacturer the CDM7160 cannot be calibrated.
Could you connect it to the pc and via the Configuration Tool enable Debug mode (send command "debug")
and then send command "cdmloop" this will make 50 readings within 2 minutes.. can you then send me the log file
you can also try to update the firmware before this via "otah"
As i understand - initially it was doing fine - and after some point of time it started to not go below 800 ?
Could you connect it to the pc and via the Configuration Tool enable Debug mode (send command "debug")
and then send command "cdmloop" this will make 50 readings within 2 minutes.. can you then send me the log file
you can also try to update the firmware before this via "otah"
As i understand - initially it was doing fine - and after some point of time it started to not go below 800 ?