Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
vThing CO2 Monitor Thingspeak update frequency setup
#3
(10-01-2016, 08:00 PM)admin Wrote: you can use
wst 10
for 10 ppm threshold
still haven't add it to config tool I think

Thank you Vladimir, this command changed interval to cca 1min which is OK for me.
Regards,
Ivan

vThing - CO2 Monitor v1.15 (CM1106 NDIR+WIFI)
vAir Monitor (CDM7160 CO2 Sensor, BME280 - Temp/Hum/Press Sensor, RF433)
Reply


Messages In This Thread
RE: vThing CO2 Monitor Thingspeak update frequency setup - by vaanja - 10-02-2016, 05:33 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)