Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Device sends %CO2% instead of the actual value
#1
Bug 
This is a known bug, that i will fix in a couple of days.
Basically it happens right after power on, while the CO2 sensor has not yet warm up
For the CM1102 this takes ~2 minutes
For CDM7160 - ~1 minute
So you would get 1 or 2 such readings.

Due to the nature of the FW it was a bit hard to fix it in a clean manner initially, this is why i left it for a later time when i get better ideas.
Reply


Messages In This Thread
Device sends %CO2% instead of the actual value - by admin - 09-23-2016, 01:42 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)