Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
433 MHZ disturbs my remote control
#6
can you try, once the device boots, before you send "nop 1"
to send
***gpio_set 12 0***gpio_set 12 F***
and then
nop 1
and check if the jamming would still occur
it may be that for some reason the GPIO responsible for the RF communication remains Floating High after power on and the device sends constantly

Also to reproduce it correctly - power it off from the usb power, and then again on - the pins go HIGH then for sure
Reply


Messages In This Thread
433 MHZ disturbs my remote control - by vbs - 02-24-2017, 04:58 PM
RE: 433 MHZ disturbs my remote control - by admin - 02-24-2017, 05:02 PM
RE: 433 MHZ disturbs my remote control - by admin - 02-24-2017, 05:15 PM
RE: 433 MHZ disturbs my remote control - by admin - 02-24-2017, 05:17 PM
RE: 433 MHZ disturbs my remote control - by vbs - 02-24-2017, 06:18 PM
RE: 433 MHZ disturbs my remote control - by admin - 02-24-2017, 08:51 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)