Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
co2 monitor v3 /cdm7160 stops sending information/ jamming 433mhz rf devices
#9
(02-24-2017, 10:41 AM)admin Wrote: Very weird
Is the device sending via wifi or only 433?
If you are use wifi, can you try to disable RF and check if it will still misbehave
I cannot find a relation between them.. But just in case
I will get new boards next week  and can send you a replacement

the device ist sending only via wifi.

when you say "disable RF" , do you mean disconnect the wires to the rf-device in the small compartment? (hardware) or just disabling in the config?

I noticed that the access point vAirMonitor_19B2B3 appears every 10 secs or so in my list of available wifis. when i try to connect to that, the connection drops. i am not able to establish a connection to that wifi ap long enough to run through the entire config procedure. 
device is still sending information to my raspberry, so it seems that it is toggling between AP vAirMonitor and my local Wifi. 
the other strange thing is that although it is possible to connect via config.vair-monitor.com to the device. but i dont see the saved attributes.
Reply


Messages In This Thread
RE: co2 monitor v3 /cdm7160 stops sending information/ jamming 433mhz rf devices - by strichter76 - 02-24-2017, 01:33 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)