Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
vESPrino Firmware
#1
The vESPrino firmware can run on any ESP8266-based board. It works better if there is an RGB led connected to GPIO2, button to GPIO 0, and expects that the I2C Bus will use some specific GPIOs, but all of this can be configured or overridden.
I will be slowly adding more information about it

It is located here:
https://github.com/vlast3k/vESPrino-firmware

The README file contains some additional information how to build or upload it
Reply


Messages In This Thread
vESPrino Firmware - by admin - 11-12-2016, 05:20 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)