09-29-2016, 04:37 PM
Hi Etienne,
I am glad that it seems to be working well.
The raw CO2 is rather a debug message that has to go away.
In general the CDM reads CO2, but it takes a minute until some internal averaging logic kicks in, and until then - the raw CO2 value is not taken int account (but i dumped it for debugging)
the CM1102 sensor works in a way that in the first 2 minutes it reports 550 ppm (i do not know why they choose this value
) ), and then it starts to report the correct values.
What were your issues with TS? I am currently reworking the configuration tool and writing (finally) some docs, so i could add this details there
Regards, Vladimir
I am glad that it seems to be working well.
The raw CO2 is rather a debug message that has to go away.
In general the CDM reads CO2, but it takes a minute until some internal averaging logic kicks in, and until then - the raw CO2 value is not taken int account (but i dumped it for debugging)
the CM1102 sensor works in a way that in the first 2 minutes it reports 550 ppm (i do not know why they choose this value
) ), and then it starts to report the correct values.What were your issues with TS? I am currently reworking the configuration tool and writing (finally) some docs, so i could add this details there
Regards, Vladimir