vThings Forums
MQTT placeholder LUX wrong - Printable Version

+- vThings Forums (http://forum.vair-monitor.com)
+-- Forum: vThings (http://forum.vair-monitor.com/forumdisplay.php?fid=1)
+--- Forum: vAir Monitor (CO2, Dust, Tempereature, etc..) (http://forum.vair-monitor.com/forumdisplay.php?fid=2)
+--- Thread: MQTT placeholder LUX wrong (/showthread.php?tid=344)

MQTT placeholder LUX wrong - Tempest - 09-02-2017

Is there a way to modify the placeholders for the MQTT messages?

The placeholder for the brightness is set to %LUX%, but it seems to me that the correct placeholder should be %LDR% (as listed when you scan sensors).
Therefore the device sends messages like this:

[Mqtt Dest: sending: to topic:LUX, msg: %LUX%]

RE: MQTT placeholder LUX wrong - admin - 09-11-2017

actually LDR is for the built in LDR sensor that simply gives out a value 0 -1000
while LUX is for the Light meters, that measure light intensity in LUX