+- vThings Forums (http://forum.vair-monitor.com)
+-- Forum: vThings (http://forum.vair-monitor.com/forumdisplay.php?fid=1)
+--- Forum: vAir Monitor (CO2, Dust, Tempereature, etc..) (http://forum.vair-monitor.com/forumdisplay.php?fid=2)
+--- Thread: vThing CO2 Monitor Thingspeak update frequency setup (/showthread.php?tid=14)
vThing CO2 Monitor Thingspeak update frequency setup - vaanja - 10-01-2016
Hi Vladimir,
I'm just testing vThing - CO2 Monitor v1.15 (WIFI+NDIR).
The sensor is on wifi, Thingspeak also working fine, but I would like to know if there is an option for adjusting data sending frequency.
Now it looks like sensor is sending update to Thingspeak on every CO2 level change (every 15 sec.)
There is no such option in Chrome config utility.
Many thanks in advance.
Kind regards,
Ivan
RE: vThing CO2 Monitor Thingspeak update frequency setup - admin - 10-01-2016
you can use
wst 10
for 10 ppm threshold
still haven't add it to config tool I think
RE: vThing CO2 Monitor Thingspeak update frequency setup - vaanja - 10-02-2016
(10-01-2016, 08:00 PM)admin Wrote: you can use
wst 10
for 10 ppm threshold
still haven't add it to config tool I think
Thank you Vladimir, this command changed interval to cca 1min which is OK for me.
Regards,
Ivan
RE: vThing CO2 Monitor Thingspeak update frequency setup - Vladimir Savchenko - 10-02-2016
and with wsi you can set interval in seconds
e..g.
wsi 120
for 120 sec
though I think this should be the default
RE: vThing CO2 Monitor Thingspeak update frequency setup - turtle - 03-27-2017
(10-01-2016, 08:00 PM)admin Wrote: you can use
wst 10
for 10 ppm threshold
still haven't add it to config tool I think
Hallo!
I recently bought the Air Quality Monitor v3 and the vThings - Wi-Fi Thermometer. Working fine.
Is it possible to setup a treshold ? At the moment it seems that the sensors report every 2 Minutes if there are changes or not.
vThings - Wi-Fi Thermometer --> only if Humidity change 1% or temperatur change 0,1 C to send a report.
Air Quality Monitor v3 --> only if CO2 change 10 ppm or Humidity change 1% or temperatur change 0,1 C to send a report.
thanks a lot ,
Bernhard
RE: vThing CO2 Monitor Thingspeak update frequency setup - admin - 03-27-2017
Hi, indeed, while the sensor used the firmware that only supported CO2 monitoring, this was working. But then i changed everything and still haven't added this.
It is on my task list, but it takes some time until i can tackle those issues
RE: vThing CO2 Monitor Thingspeak update frequency setup - turtle - 03-28-2017
(03-27-2017, 10:56 AM)admin Wrote: Hi, indeed, while the sensor used the firmware that only supported CO2 monitoring, this was working. But then i changed everything and still haven't added this.
It is on my task list, but it takes some time until i can tackle those issues
Hallo!
Would be great.
thanks,
bernhard