(09-27-2016, 03:52 AM)admin Wrote: i think i managed to fix it, at least the device was running for 1 hour sending each 10 seconds and there was not a single hickup
I won't push this as a general update for now, so you can update to the latest version by sending a command
otah
Got my device yesterday, configured it and everyting was working fine. Placed it in the living room and noticed that since then CO2 wasn't updating.
Now connected to my computer I see %CO2% is sent instead of the value. In the output I see "Raw CO2: -2]".
I sent command otah but it did not matter.
(09-29-2016, 06:12 PM)freakstar Wrote:(09-27-2016, 03:52 AM)admin Wrote: i think i managed to fix it, at least the device was running for 1 hour sending each 10 seconds and there was not a single hickup
I won't push this as a general update for now, so you can update to the latest version by sending a command
otah
Got my device yesterday, configured it and everyting was working fine. Placed it in the living room and noticed that since then CO2 wasn't updating.
Now connected to my computer I see %CO2% is sent instead of the value. In the output I see "Raw CO2: -2]".
I sent command otah but it did not matter.
Powered the device off for a couple of minutes, now it looks like it is working again!