Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Device sends %CO2% instead of the actual value
I'd just like to add, that mine two sensors also stops sending data after about ¾ of a day.
From the other thread I've limited the voltage of the power supply already being below 5,25V without change of behavior.
As far as I can remember somewhen in the past the sensors worked properly without interruption. Unfortunately and for sure I did not note the date or firmware version for which it worked well. 
Therefore currently just following this thread also, hoping for a solution and avoiding to update to the recent firmware.

Messages In This Thread
RE: Device sends %CO2% instead of the actual value - by joshi04 - 12-30-2016, 09:14 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)