Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Device sends %CO2% instead of the actual value
I updated the configuration program and the device firmware the other day (Friday, I think). Only immediate problem was that I did the configuration program first and it started sending commands with the “!” which confused the old firmware. When I did a factory reset I then had to do the command to reset the wifi manually without the “!” in order to do the “otah” command.

I like the new layout of the configuration utility with the tree-list down the left-hand side: makes it a lot tidier.

I couldn't see where to configure the sampling rate but the default two minutes is fine, really.

What's a bit more disturbing is that it's twice dropped back to reporting all parameters (temperature, pressure, altitude, humidity and CO₂) in %xxx% form rather then numerically. Unplugging it and plugging it again has reset it which is annoying as there's no way to fiddle with it with the config utility without doing that.

I've left it plugged into a USB hub plugged into my laptop in the hope it'll do it again but it hasn't so far.

Messages In This Thread
RE: Device sends %CO2% instead of the actual value - by Ed Davies - 12-18-2016, 07:40 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)