Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
co2 monitor v3 /cdm7160 stops sending information/ jamming 433mhz rf devices
#21
(02-24-2017, 07:19 PM)strichter76 Wrote: i am attaching full log.

I have discovered several problems, but the most critical one, for your case whas the fact that the Config tool was storing wrong URLs in case of Pimatic w/o password.
I am sure there are quite a few people from the pimatic community that bought the devices, but perhaps, they either used a password, or have been setting up this manually, (or simply do not use the device Smile    
I any case this is now fixed in the online configuration, and in the chrome app it will be pushed perhaps in a couple of hours
then you will need just to re-save your pimatic configuration and try it again

this is not related to the jamming though, for this i will make a firmware change once i verify some other stuff.
Reply


Messages In This Thread
RE: co2 monitor v3 /cdm7160 stops sending information/ jamming 433mhz rf devices - by admin - 02-25-2017, 02:38 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)