Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
co2 monitor v3 /cdm7160 stops sending information/ jamming 433mhz rf devices
#15
(02-24-2017, 06:48 PM)admin Wrote: No.. Rather try disabling it from the config tool
To see if it still fail.
Also try iy while connected to the config tool
And send a command
"nop 1"

I am on latest firmware again. 433 MHz jamming even happens for me after disabling RF in config and restarting.

Also it is ok right after startup. It immediately starts to happen when sending "nop 1".
Reply


Messages In This Thread
RE: co2 monitor v3 /cdm7160 stops sending information/ jamming 433mhz rf devices - by vbs - 02-24-2017, 07:42 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)