Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
New Functionalities in Build 2017.02.19
Sucesfully updated older CM1106 version. The only outstanding questions are regarding CO2 LED levels - How are levels/colors calculated? Is it specific for every sensor? As far as I know there are different max. levels for each sensor type so I would like to know if e.g. for 2000ppm will be set to violet LED for all types of sensors. (some of them hax max. level 2000ppm and another 10000ppm).
Also for wifi config - I'm not able to use configuration via wifi - my sensor has got IP from DHCP, but not working at all (tested on chrome, firefox, edge, IE). Any hint how to use wifi config?

After some testing I found I need to disable deep sleep if I want to have CM1106 configurable via wifi (Go to sleep time(sec):0)

vThing - CO2 Monitor v1.15 (CM1106 NDIR+WIFI)
vAir Monitor (CDM7160 CO2 Sensor, BME280 - Temp/Hum/Press Sensor, RF433)

Messages In This Thread
RE: New Functionalities in Build 2017.02.19 - by vaanja - 02-19-2017, 01:31 PM

Forum Jump:

Users browsing this thread: 3 Guest(s)