01-12-2017, 06:34 AM
can you remind me what kind of sensors your device had
it seems to find a CO2 Sensor and Dust Sensor, right ?
The config tool is not yet too smart
and if you give configuration also for other values (temperature, pressure, etc) it will configure them, but then the firmware on the device would not sent them (hence the -13 response code).
What confuses me a bit from the logs is that there should be an entry with reported values from all sensors
can you try to enable Debug (from Settings) and then send me the logs again
(about the wifi network, i will soon fix this so that it doesn't dump confidential data )
it seems to find a CO2 Sensor and Dust Sensor, right ?
The config tool is not yet too smart
and if you give configuration also for other values (temperature, pressure, etc) it will configure them, but then the firmware on the device would not sent them (hence the -13 response code).What confuses me a bit from the logs is that there should be an entry with reported values from all sensors
can you try to enable Debug (from Settings) and then send me the logs again
(about the wifi network, i will soon fix this so that it doesn't dump confidential data
)