Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Device sends %CO2% instead of the actual value
I'm a bit confused now: as of 2016-12-22 Thur 14:57Z my current version is 20161217 but the last %TEMP%, etc, entry in my log files is for just after midnight on the 18th:

mqtt-2016-12-17T20:06:43Z.log:{"_": "2016-12-18T00:03:29Z", "sophie": {"altitude": "%ALT%", "co2": "%CO2%", "humidity": "%HUM%", "pressure": "%PRES%", "temperature": "%TEMP%"}}

That's probably with a previous version.

What I have had since then is it stop recording on a previously known-good power supply in much the way it does with suspect power supplies. One time when I unplugged it and plugged it in again after such a stop the light went bright red for a while: could it have done a firmware upgrade without my explicitly asking for it?

Just done another update (at 2016-12-22 Thur 15:04Z) to get today's firmware 20161222 (vESPrino v1.16 build20161222). Will see how that goes.

Messages In This Thread
RE: Device sends %CO2% instead of the actual value - by Ed Davies - 12-22-2016, 03:01 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)