co2 monitor v3 /cdm7160 stops sending information/ jamming 433mhz rf devices

[admin]

hmm this is strange and i really hope there is a hardware issue
(i already had a couple of boards with 1 pin shorted)
can you please try following
gpio_set D6 0
gpio_set D6 F
gpio_get D6

you should get at the end
gpio_get D6
GPIO6 (12) :0
ready >]

if you get
GPIO6 (12) :1

then the problem is hardware and i will send you a new main board right away
you can also then try to remove the whole addon board that connects to the main board
to verify that the command will still return 1