Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[SOLVED] No connection through the config tool
#1
Hey guys,

I just received my VAir Monitor (C02-CDM7160 with RF433)
I plugged it in, did the Wifi Set-up but got stuck.

After changing the SSID to my home network it displayed all the correct LED colors and timings.
The device is showing up on my router with its mac address.
However, when I ping to the device (IP address corresponding to the devices mac address). I get no response.
When I go to: http://config.vair-monitor.com/ and click on "Auto connect" it never finds the device.

I flashed the device to the latest firmware and did two factory resets through the serial interface.
I also tried "Firmware20161006"

I also tried connecting to the device using the chrome application.
This is the output:
Quote:Trying : COM1

Trying : COM3

 .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  . Searching for v.Air Trying : COM5

The device is connected to my computer through COM5.

When I re-boot the device and try it again I get a different output: (Even though the application says "Not Found")
Quote:Trying : COM1

Trying : COM3

rcv: info

vESPrino v1.16 build2017
rcv: 0203
IP address: 192.168.0.17

rcv: Chip ID: 10473C

rcv: ready >

 .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  . 


Can someone shed some light on this?
Also, is it normal that the device shuts itself off after a few minutes?
Reply


Messages In This Thread
[SOLVED] No connection through the config tool - by wokkelp - 02-14-2017, 08:07 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)