02-01-2017, 06:41 PM
Thank you very much Vladimir.
Now it's working again. I was flashing this device with firmware dedicated to vesprino family.
So for those using CO2 Single Beam Sensor for Home Automation integration don't use vesprino firmware!
Also use version 5.2 of Chrome config utility to configure wifi/thingspeak etc. (vThings - Device Configuration Tool 8.7 not working for this device.)
Everything is clearly described here: http://vair-monitor.com/device-types/
Now it's working again. I was flashing this device with firmware dedicated to vesprino family.
So for those using CO2 Single Beam Sensor for Home Automation integration don't use vesprino firmware!
Also use version 5.2 of Chrome config utility to configure wifi/thingspeak etc. (vThings - Device Configuration Tool 8.7 not working for this device.)
Everything is clearly described here: http://vair-monitor.com/device-types/
vThing - CO2 Monitor v1.15 (CM1106 NDIR+WIFI)
vAir Monitor (CDM7160 CO2 Sensor, BME280 - Temp/Hum/Press Sensor, RF433)