RF Connectivity

[wokkelp]

Hi Vladimir,

I was able to recieve data through RF 433 but somehow after a while it stopped updating even though it still updated through http.


I have no clue what the value fields are for in the RF 433/315 option menu... Even though I read something about it in this topic, I still have no clue.

Output:

Quote:---Sending data---
CustomHTTPDest::process]
[Calling HTTP: [http://192.168.0.5:8080/json.htm?type=command&param=udevice&idx=76&nvalue=1002]
CLOSED
Response Code: 200]
[CustomHTTP : 235ms
SerialDumpDest::process
IP : 192.168.0.19
CHIPID : 10473C
RUNTIME : 1446
GMTTIME : 59635649
RSSI : -55
CO2 : 1002
CO2R : 983
SerialDump : 158ms
MQTTDest::process]
[MQTT : 97ms
RFDest::process]
[RFX10 : 1525ms
Blynk : 0ms]

Because you asked someone to open up his device I did that too, to see if everything was connected properly.
As soon as I lifted off the larger plate I noticed that the green and yellow wire were pierced by one of the screws...

The RF module did work so I have no idea what the impact actually is, but the green and yellow wire might shortcircuit because the insulation is also damaged. Can you give me some advice?


+ enlarge.


Also, side note, what is the CO2R value?
and, come to think of it, what is the button on the device for?