RF Connectivity

[nmaster]

Hi,

I got my vAir monitor with RF 433 option last week.

I want to enable RF to get values over RF 433, received by my rfxcom attached to a raspberry pi running domoticz.

In the config tool, what are the form fields under the "Enable RF" checkbox used for ?
There is one for each sensor.

What I would like is to disable wifi, and only use rF 433 if doable.

Thank you.

---

I activated RF, and I got values in each field.

Now my rfxcom doesn't see anything.

What protocol must I activate on the rfxcom to get sensors values ?