Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MQTT placeholder LUX wrong
#1
Is there a way to modify the placeholders for the MQTT messages?

The placeholder for the brightness is set to %LUX%, but it seems to me that the correct placeholder should be %LDR% (as listed when you scan sensors).
Therefore the device sends messages like this:

[Mqtt Dest: sending: to topic:LUX, msg: %LUX%]
Reply
#2
actually LDR is for the built in LDR sensor that simply gives out a value 0 -1000
while LUX is for the Light meters, that measure light intensity in LUX
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)